WEBLEY MARK VI SHAVED CYLINDER FULL CONVERSION PLATE BACK TO 455

MADE OF HARDENED AND TEMPERED TOOL STEEL. THICKNESS 0.047.

BEFORE PURCHASIBG YOU SHOULD CHECK YOUR HEADSPACE. THIS CAN BE DONE IN 2 WAYS: INSERT A 0.093 SHIM BETWEEN THE UPPER PART OF THE CYLINDER AND THE RECOILL SHIELD FIT SHOULD BE SNUG WITH NO GAP. THE SECOND METHOD IS TO MEASURE THE LENGTH OF THE CYLINDER FROM FRONT TO BACK (SHOULD MEASURE 1.456 JUST SHY OF 1 1/2 INCHES). NEXT, WITH A CARTRIDGE AT THE TOP OF THE CYLINDER (IN THE FIRING POSITION) WITH THE CONVERSION PLATE INSTALLED THERE SHOULD BE A GAP OF APPROX. 0.003.TO 0.005 WHICH IS IDEAL. THE REASON FOR CHECKING HEADSPACE IS BECAUSE SOME CYLINDERS WERE SHAVED FOR 45 LC INSTEAD OF 45 ACP. ACP IS THE MOST COMMON AND THAT IS WHAT THIS PLATE IS DESIGNED FOR. ALSO EVEN IN 45 ACP SOME VARIATIONS MAY OCCUR. SOME SHAVED CYLINDERS ARE NOT SHAVED ALL THE WAY DOWN ON THE RATCHET POST AND A SLIGHT TAPERED SHOULDER MAY BE PRESENT AT THE BOTTOM. THE CENTER HOLE IN THE PLATE SHOULD BE BIG ENOUGH TO PASS OVER BUT IF NOT THE SHOULDER MAY HAVE TO BE FILED. 455 WEBLEY CARTRIDGES ARE AVAILABLE FROM FIOCCHII THIS WILL ALLOW YOU TO FIRE THE SAFER 455 LOADS

.

EAST TAYLOR, LLC 1101 ANDERSON ROAD STATESBORO GA 30458

TELEPHONE 912 839 4769

EMAIL: schwartz@partsforantiqueguns.com.

 

"0" src="https://www.paypalobjects.com/en_US/i/scr/pixel.gif" width="1" height="1">