Contact Us

Home

REMINGTON MODEL 10 BAYONET ATTACHMENT

All steel reproduction of the Remington Model 10 Bayonet Attachment. The Remington Bayonet Attachment had a separate wooden handguard instead of a ventilated steel heat shield. The wooden upper handguard did not come in contact with the rear of the bayonet attachment. The front sling swivel was not a part of the bayonet attachment but rather was attached to the magazine tube just to the rear of the magazine plug. The attachment comes with all 4 mounting screws and brass bead sight. It ships in the white (you must color it to match your gun). Ships within 10 business days from receipt of payment.

The correct barrel length for the Remington Model 10 is 23 inches, measured from the breach to the muzzle. After cutting the barrel to the correct length you should file one shallow groove in the underside of the barrelfor the under barrel set screw to seat into. To locate the groove slide the attachment onto the barrel until the front of the bayonet lug (cylindrical projection) is even with the end of the barrel. Scribe a mark on the underside of the barrel through the set screw hole in the bottom of the attachment. Remove the attachment and file the groove.

$125.00 IMPORTANT: IF YOU HAVE AN ORIGINAL MODEL 10 TRENCH GUN YOU MUST NOTIFY US BEFORE ORDERING

 

 

REMINGTON MODEL 10 UPPER HAND GUARD

PRICE $125.00 IMPORTANT: IF YOU HAVE AN ORIGINAL MODEL 10 TRENCH GUN YOU MUST NOTIFY US BEFORE ORDERING.

SHIPPING $10.00

 

American walnut reproduction of the rare Remington Model 10 hand guard. Comes unstained with the forward hold down clip riveted to it. Also includes the rear metal hold down clamp and two 6-32 screws (you must drill and tap your frame). Your barrel should be 23 inches long. To install the hand guard you must remove the magazine support strut in order for the front clip on the hand guard to slide past it. Once the hand guard is in place you can re-install the magazine tube support strut.

 

REMINGTON TRENCH GUN FORWARD SLING SWIVEL

PRICE: $48.00

SHIPPING: $4.00

 

The forward sling swivel matches the butt stock sling swivel with the following exceptions: it is attached to the underside of the magazine tube. The bottom of the swivel plate is concave to conform to the shape of the tube. To attach it to the tube you must remove the magazine locking plug and drill out the existing threaded hole (the one on the underside that holds the plug in place) and tap it to accept a 10 - 32 screw (2 are provided with the sling swivel). Next drill out the existing hole in the tube to 3/16. You then install the magazine locking plug in the tube and screw the swivel in place (using the front hole in the swivel). Next, using a number 19 drill go through the rear hole in the swivel drilling all the way through that side of the magazine locking plug. Once again remove the magazine locking plug, tap the new hole to 10 - 32 and drill out the corresponding hole in the magazine tube to 3/16. Re-install the magazine locking plug and screw down the sling swivel.

 

TRENCH GUN BUTT STOCK SLING SWIVEL

PRICE: $32.00

SHIPPING: $4.00

This is the correct 1-3/8 inch long butt stock sling swivel for original Winchester 97 and Model 12 trench guns. It is perfect for your conversion project as well. Comes with 2 wood screws.

 

COMPLETE SET - BAYONET ATTACHMENT HAND GUARD AND BOTH SLING SWIVELS

PRICE: $295.00

SHIPPING: $11.00